Installation method and maintenance steps of fully automatic pipe bending machine

1. The installation method of the fully automatic pipe bending machine should be reasonable, and the fulcrum should be at 1/4 of the total length of the laser tube. Otherwise, it will cause the laser tube spot mode to deviate. Some pipe bending machines will have several spots during operation, resulting in laser power attenuation and equipment power failure to meet processing requirements, resulting in the pipe bending machine being unusable or damaged!

2. The constant temperature water circulation protection system should be regularly cleaned, inspected, maintained, and maintained. If there are any debris, it can easily cause the laser tube to burst or the cold water head to fall off. Short circuits cannot be used to solve emergency shutdowns. The circulating cooling water quality is good,

3. The exhaust system should be regularly inspected, cleaned, and maintained, otherwise it may cause excessive smoke and dust, which can contaminate the reflective and focusing lenses and laser tubes, causing unstable equipment performance.

4. Focus lenses and reflectors should be inspected regularly. After working for a period of time, the frame will heat up, and the surface of the lenses will discolor, peel off, and rust; Film detachment and cracking are all objects that need to be replaced, especially many customers use large air pumps and compressors, which quickly accumulate water on the focusing lens,

5. The working environment of the fully automatic pipe bending machine is good. If the ambient temperature is between 18 ° C and 30 ° C, there should not be too much dust and air pollution should not be too severe, otherwise it will cause serious damage to the pipe bending machine and the failure rate will continue to rise;

6. The power supply voltage should not be too high or too low

7. The correct method should be used for cleaning the optical system, otherwise it may lead to premature aging and rupture of the laser tube. Therefore, the working time of the bending machine should be set at 50-60%, and then the working speed should be adjusted according to the material, which is the best working state of the laser tube.

8. The bottom plate and the processed material should be flat, otherwise it may cause inconsistent focal length and some areas that cannot be cut through. This will increase the light intensity and also cause rapid aging of the laser tube.

9. The heat dissipation of the laser power supply should be smooth, otherwise once the working current is adjusted by more than 50%, the temperature will rise very high, which will increase the failure rate of the laser power supply.